First time.
Well I finally got everything rounded up to start practicing with my new HP CS. It was somewhat less than successful. I fought with the paint the whole time. It went from splattering to clogging completely several times. I went thinner, thicker, every thing I could think of. These were the conditions:
Createx opaques (reduced with water)
PSI- 10 to 30 (varied. Seemed to work best at 20)
Poster board
70 deg. inside
30 deg where compressor is located (cold air maybe?)
I had to clean it a lot, but I did get it to spray good a few times, so I know it can be done. Any suggestions are welcome. Here is a doodle from the mess.
|